Hits on the Living House Website
Unique Visitors to the Living house

© 2016 Living House

The Living House is targeting Passive House certification. 

 

According to the Passive House Insitute of New Zealand Passive House is a fabric first approach to achieving healthy and comfortable buildings. The fabric (or thermal envelope) typically has a long life cycle, so it makes sense to prioritise your planning and investment here. The Passive House standard is first and foremost about delivering on a promise: a comfortable, well ventilated home that needs very little energy.

Passive House explained in 90 seconds

Passive House requirements

For a building to be considered a Passive House, it must meet the following criteria:

1. The Space Heating Energy Demand is not to exceed 15 kWh per square meter of net living space (treated floor area) per year or 10 W per square meter peak demand.

In climates where active cooling is needed, the Space Cooling Energy Demand requirement roughly matches the heat demand requirements above, with an additional allowance for dehumidification.

2. The Renewable Renewable Primary Energy Demand (PER, according to PHI method), the total energy to be used for all domestic applications (heating, hot water and domestic electricity) must not exceed 60 kWh per square meter of treated floor area per year for Passive House Classic. .

3. In terms of Airtightness, a maximum of 0.6 air changes per hour at 50 Pascals pressure (ACH50), as verified with an onsite pressure test (in both pressurized and depressurized states).

4. Thermal comfort must be met for all living areas during winter as well as in summer, with not more than 10 % of the hours in a given year over 25 °C. 

All of the above criteria are achieved through intelligent design and implementation of the 5 Passive House principles: thermal bridge free design, superior windows, ventilation with heat recovery, quality insulation and airtight construction.

The following basic principles apply for the construction of Passive Houses:

 

Thermal insulation : All opaque building components of the exterior envelope of the house must be very well-insulated. For most cool-temperate climates, this means a heat transfer coefficient (U-value) of 0.15 W/(m²K) at the most, i.e. a maximum of 0.15 watts per degree of temperature difference and per square metre of exterior surface are lost.

Passive House windows: The window frames must be well insulated and fitted with low-e glazings filled with argon or krypton to prevent heat transfer. For most cool-temperate climates, this means a U-value of 0.80 W/(m²K) or less, with g-values around 50% (g-value= total solar transmittance, proportion of the solar energy available for the room).

Ventilation heat recovery : Efficient heat recovery ventilation is key, allowing for a good indoor air quality and saving energy. In Passive House, at least 75% of the heat from the exhaust air is transferred to the fresh air again by means of a heat exchanger.

Airtightness of the building: Uncontrolled leakage through gaps must be smaller than 0.6 of the total house volume per hour during a pressure test at 50 Pascal (both pressurised and depressurised).

Absence of thermal bridges ; All edges, corners, connections and penetrations must be planned and executed with great care, so that thermal bridges can be avoided. Thermal bridges which cannot be avoided must be minimised as far as possible.